Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Here is a small power supply project that I would like to share with all the members of this forum.
PLEASE SEE BOTTOM OF PAGE FOR FINAL PROJECT PICTURES
The project is centered on the LM317T regulation chip:
http://www.national.com/pf/LM/LM317.html
NOTE: The supply can be configured...
Peter_wadley submitted a new article:
ULTRA clean 9VDC Power Supply Project - Here is a small power supply project that I would like to share with all the members of this forum.
Read more about this article...
If an alternator requires more current ... it becomes harder to rotate.. agreed
If an electrical load is added to your car alternator... the alternator is harder to turn ... which makes it harder for the engine to turn ... when this happens how does the engine continue to spin at the same RPM...
hello
I tried using the 9V with a diode but it did not work
I used the following setup:
------ + ----- |> -------------------- POSITIVE LEAD OF BOOSTER
9v DIODE
------ - -------------------------------NEGATIVE LEAD OF BOOSTER
hmmmmmmmmmmmm
Thanks for the reply MikeML
Can anyone explain what would happen if I did try connecting a smaller SLA battery to activate the relay?? The package is pretty rugged and looks hard to open...
Would the boost just charge the smaller SLA until it reaches the same voltage as the booster battery??
Hello
I bought a motomaster 22AH Lead Acid Booste car Booster Pack with 700 CCA
I wanted to use it for boosting my car in cold weather AND other things such as power a 1000 WATT inverter in cases such as a power failure.
Problem: The booster only activates if it senses a voltage of > 3.5...
Article: ULTRA clean 9VDC Power Supply Project
You can view the page at https://www.electro-tech-online.com/articles/ultra-clean-9vdc-power-supply-project.86/
Like I said I'm no audiophile.. My ears are pretty daft to the difference between OK and GREEEEEEEAT (tony the tiger)
Is anyone able to tell me what Gauge I should use from the AMP to the SUB?
I tried to use volt meter on the AMP outputs but got only order of millivolts
The CEA-2006 Power Rating is ([email protected] = 1%THD+N), S/N 75dBA (Ref. 1W into 4Ohm):300W x 1
so it has been officially auditied correct?
Why on earth would they use 40 ohm? or is that 4ohm?
Hey guru,
The Alpine site states:
RMS Power (at 14.4V THD+N, 20-200Hz)
Per channel into 4 ohms: 300W x 1 (0.08% THD)
Per channel into 2 ohms: 500W x 1
OK I am using one 4 OHM sub
So the RMS power is 300W not the peak ... 300 is the RMS from their site. This thing really is...
Hey Hey,
I just bought the 500W RMS Alpine sub amp from Futureshop that is on sale this week
It's marked down $100!! from 299.99 to 199.99 .. I highly recommend it!
My question:
From the 12 v car Battery I am using 8 AWG for the + and - Leads.. since the voltage is so low and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
