Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Hi again
well i connected a .5 ohm resistor to the current sensing pins of the l298. I am still not getting the output in the range of my vss all i am getting is a 0 v to 5 v output. I am using a simple power adapter which is set to give 15 v but its current is limited to 500 mA as written on...
Hello Everyone
I am using an atmega 16 and l298 to control a sanyo 103h7121-1311 stepper motor. i have connected the current sensing pins of the l298 to gnd.
i am using a 15 vss, but what i am getting as output is only 5 v. Is it because of the absence of any sensing resistors, if so please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.