Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
can it be repaired??? if no then
sir can i built a circut which can recieve the transmitted data from tws434??
if yes can you provide me the ckt diag and the component list
i have an issue with rws 434 its +ve and -ve terminals are short is it faulty????
can any one tell help me to build a circuit to recieve the transmitted signals form tws434 coz i cant buy another rws434 what would be the value of l1 for receiving 433mhz signal???
sir the 78l05 was faulty i hav checked it..
i connected another regulator but it was givin 5v initially but laterr it was blown of heat.. y did this happened???
i hav connected 2 capacitors 10 uf and 100uf in parellel with it. is it ok??
what if i connect the data out of the encoder to the data in of the decoder will it work with the same circuit or i have 2 do any modifications
its giving 4v at the out put is it sufficient ????
i have used the following circuit for the regulator.
How to build a +5V regulator using 78L05 / 7805 – Dedication to DIY and programming
and i m applying 5 v to the transmiter..
sir i hav connected 78l05 to the circuit and its giving 4 - 5 v output but still the circuit is not working i have used the following link to build the circuit but still its not working how shal i test the circuit
http://www.rentron.com/PicBasic/8-BIT-RF2.GIF
please help
dear sir i hav read the data sheet but i m confused abt the reciever ill try connecting the regulator and ill reply back to you.
Sir can i have your email id so that i can contact u..
Hi friends in am building up an rf transmitter and receiver circuit ht640and ht648l
i m using 12v battery for the circuit but can i use rws 434 rx at 12 v supply ??? if no which resistor should i use to limit the supply please help ........
how much volt does it require for proper...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
