Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
wuming79,
You are lucky to get a lot of good feed backs. If all doesn't work, then try this.
Apply soldering "flux" prefer "no-clean",many electronics components retailers carry it. If not, Home Depot has flux and solder also.
Well apply flux to both side of the board and touch one lead at a...
roboticmisinfo,
You can try to de-solder each pin and risk lifting the pads and barrels, or if you have a solder pot (you can get a used one on the web for $50 or less) put kapton tape over the surounding area to isolate it from cantacting the solder in the pot and also prevent heat transfer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
