Here's a simple lie detector that can be built in a few minutes, it is mean for fun and is obviously not very accurate. It works by measuring skin resistance, which goes down when you lie.
Schematic
Parts
R1 - 33K 1/4W Resistor
R2 - 5K Pot
R3 - 1.5K 1/4W Resistor
C1 - 1uF 16V Electrolytic Capacitor
Q1 - 2N3565 NPN Transistor
M1 - 0-1 mA Analog Meter
MISC - Case, Wire, Electrodes (See Nots)
Notes
1. The electrodes can be alligator clips (although they can be painful), electrode pads (like the type they use in the hospital), or just wires and tape.
2. To use the circuit, attach the electrodes to the back of the subjects hand, about 1 inch apart. Then, adjust the meter for a reading of 0. Ask the questions. You know the subject is lying when the meter changes.
Schematic
Parts
R1 - 33K 1/4W Resistor
R2 - 5K Pot
R3 - 1.5K 1/4W Resistor
C1 - 1uF 16V Electrolytic Capacitor
Q1 - 2N3565 NPN Transistor
M1 - 0-1 mA Analog Meter
MISC - Case, Wire, Electrodes (See Nots)
Notes
1. The electrodes can be alligator clips (although they can be painful), electrode pads (like the type they use in the hospital), or just wires and tape.
2. To use the circuit, attach the electrodes to the back of the subjects hand, about 1 inch apart. Then, adjust the meter for a reading of 0. Ask the questions. You know the subject is lying when the meter changes.