Tamil.selvam
New Member
Hi everyone.....hope all is well with you guys.....i have designed a simple switching circuit that switches between a number of measured voltages....this then goes through a ADC circuit which converts the analog voltages to digital.....i have D0 to D7 coming out of the ADC.....the problem is i have to display the voltages on the LCD on a Proton development board version 1.0, I have no clue where to begin, as i have never done PIC programming before this......i'm using a 16F877A.....can someone please point me in the right direction.....thanks.
regards
tamil
regards
tamil