1. Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
    Dismiss Notice

Torn trace, SMD, possible to repair?

Discussion in 'Repairing Electronics' started by halleffector, Jun 18, 2017.

  1. halleffector

    halleffector Member

    Joined:
    Jan 30, 2016
    Messages:
    98
    Likes:
    0
    See the attached images. I tore the lower trace for that little IC. Is there anything that can be done about this?

    There is no visible via going to the other side that I can jump a wire to. I even tried digging into the resin of the PCB to see if I could find a small trace to solder onto, but I guess that was a bad idea.

    [​IMG] [​IMG]
     
  2. ronsimpson

    ronsimpson Well-Known Member Most Helpful Member

    Joined:
    Apr 17, 2007
    Messages:
    7,248
    Likes:
    961
    Location:
    Loveland, CO USA
    I can not see; but maybe the IC pin goes nowhere.
     
  3. ramondo

    ramondo New Member

    Joined:
    Dec 13, 2016
    Messages:
    10
    Likes:
    0
    Location:
    Youngstown,Ohio USA
    What kind of board is it? Someone may have one to compare. Pictures on shopjimmy may help. also check datasheet of ic for pinouts.
     
  4. dave

    Dave New Member

    Joined:
    Jan 12, 1997
    Messages:
    -
    Likes:
    0


     
  5. halleffector

    halleffector Member

    Joined:
    Jan 30, 2016
    Messages:
    98
    Likes:
    0

    Actually it is not needed, excellent. Thanks!
     

Share This Page