Mosaic
Well-Known Member
Hi guys.
I have a board and no matter how small I set the DRU spacing between traces/pads etc..Eagle seems to complain. I went down to 1 mil for ALL DRU clearances and it still complains about clearance. It seems to be wanting 15 mil min. By zooming in and setting the grid to 1 mil I can get a reasonable measure of the clearances it's hilighting. It's even complaining about pad spacing between library SMD device pads for SOT 6 devices.
Any thoughts?
I have a board and no matter how small I set the DRU spacing between traces/pads etc..Eagle seems to complain. I went down to 1 mil for ALL DRU clearances and it still complains about clearance. It seems to be wanting 15 mil min. By zooming in and setting the grid to 1 mil I can get a reasonable measure of the clearances it's hilighting. It's even complaining about pad spacing between library SMD device pads for SOT 6 devices.
Any thoughts?
Last edited: