1. Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
    Dismiss Notice

Problem with CAD eagle: How to draw board space?

Discussion in 'General Electronics Chat' started by Robot builder 101, Aug 2, 2007.

  1. Robot builder 101

    Robot builder 101 Guest

    ONLINE
    Lol, How do I draw a blank board? Like the outline?
     
  2. Pommie

    Pommie Well-Known Member Most Helpful Member

    Joined:
    Mar 18, 2005
    Messages:
    9,687
    Likes:
    277
    Location:
    Brisbane Australia
    Use the wire command and set the layer to dimension and the width to zero.

    Mike.
     
  3. justDIY

    justDIY Active Member

    Joined:
    Mar 1, 2005
    Messages:
    1,723
    Likes:
    12
    Location:
    Michigan, USA
    if you're going to do the board yourself, 0 is fine. if you're going to have a board house do it, use their guideline for minimum line width (usually 6 - 10 mils).
     

Share This Page