1. Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
    Dismiss Notice

Pic prgrammer and software

Discussion in 'Microcontrollers' started by Chippie, Mar 9, 2003.

  1. bogdanfirst

    bogdanfirst New Member

    Joined:
    Dec 13, 2002
    Messages:
    1,310
    Likes:
    1
    Location:
    Ramnicu Valcea, Romania
    ok, i stii have one more question about your programmer.
    can i use it to program a 12C508A and a 12V509A?
     
  2. Chippie

    Chippie New Member

    Joined:
    Mar 8, 2003
    Messages:
    991
    Likes:
    9
    Location:
    Good 'ole England
    Yup sure does, use IC-Prog software.......place the 12Cxxx in the ic holder.........pin1 to pin 1........i.e use the first 4pins on the ic holder........for a 16F84 etc.......just plug straight in.

    For a 24C xx eeprom, place in the holder so that pin 1 of the eeprom is socketed at pin pin5.......so pins 1-4 of the eeprom are inserted into pins 5-8 on the holder


    HTH Chip....

    ps its not my programmer... :wink:
    http://www.jdm.homepage.dk/ is the owner......I just did the pcb
     
  3. bogdanfirst

    bogdanfirst New Member

    Joined:
    Dec 13, 2002
    Messages:
    1,310
    Likes:
    1
    Location:
    Ramnicu Valcea, Romania
    thanks a lot!
     

Share This Page