1. Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
    Dismiss Notice

Need some help with Eagle and pads vs vias et al

Discussion in 'Circuit Simulation & PCB Design' started by tagaide, Feb 11, 2013.

  1. jpanhalt

    jpanhalt Well-Known Member Most Helpful Member

    Joined:
    Jun 21, 2006
    Messages:
    5,897
    Likes:
    502
    Location:
    Cleveland, OH, USA
    A few years ago, I was helping a fellow near Cleveland with milling a PCB. He had a Tormach Personal CNC and was able to convert/load the Eagle files. I do not recall the program he was using, as I had no plans for CNC at that time.

    You might check with Tormach or post to its forum.

    John
     
  2. tagaide

    tagaide New Member

    Joined:
    Jan 31, 2013
    Messages:
    24
    Likes:
    0
    Its fine john, it was the poly's that made things a bit too complicated.
    either , if you dont mind i 'll keep you posted on how things go. its been a great ride so far!
     
  3. jpanhalt

    jpanhalt Well-Known Member Most Helpful Member

    Joined:
    Jun 21, 2006
    Messages:
    5,897
    Likes:
    502
    Location:
    Cleveland, OH, USA
    I would love to be updated. The poly problem is understandable.

    John
     

Share This Page