L298n and PIC connections

[the spirt]

iam working on line follower project
i want to know howa i connect PIC with the motor driver l298n

components :
PIC 18f452
motor driver L298n
3 dc motor(24volt,4200rpm) : 2 back and 1 front

please give the wright pin conections as soon as possible ... thank you

 

[ericgibbs]

hi,
This link is an easy start tutorial for a H bridge.
https://www.nathandumont.com/node/249

The correct pin connections will be determined by the programming of the PIC, are you doing the programming.?

If yes, which program language.?

 

[the spirt]

i make the programming for line follower sesnor , i want to make the programmaing for motor driver to complete my project, so i want to know how i connect the l298n motor driver to the pin of PIC type i mention ...... i used MicroC programming language .... thanks for your replay

 

[panic mode]

did you check the link?
there is a circuit for your chip, you just need three outputs from PIC
https://www.nathandumont.com/files/images/hbridge_l298_parallel.png

 

[koolguy]

3 dc motor(24volt,4200rpm)

are u sure with this RPM?