Hi Looking for some advice
I've got 2 HDMX Jam wireless speakers (HX-P230A) both had a charging fault due to damaged micro USB connector.
I've desoldered and replaced one which now works fine.
The other speaker has 2 missing board pads for pin 2 & 3, it seems like the 5 pins exit the connector and run to the same point on the board, can I simply bridge the pins that are damaged?
If not does anyone have any info on these boards the internet was somewhat unhelpful as far as board diagrams go.
Thanks for any help.
I've got 2 HDMX Jam wireless speakers (HX-P230A) both had a charging fault due to damaged micro USB connector.
I've desoldered and replaced one which now works fine.
The other speaker has 2 missing board pads for pin 2 & 3, it seems like the 5 pins exit the connector and run to the same point on the board, can I simply bridge the pins that are damaged?
If not does anyone have any info on these boards the internet was somewhat unhelpful as far as board diagrams go.
Thanks for any help.