1. Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
    Dismiss Notice

about 16f84a programer (quark)

Discussion in 'Microcontrollers' started by amadeus, May 14, 2003.

  1. amadeus

    amadeus New Member

    Joined:
    May 14, 2003
    Messages:
    3
    Likes:
    0
    Location:
    Mèxico D.F.
    Hello everybody, recently i found a diagram of a programer of pics 8,18 and 28 (i can`t remember fine the last one, but its something near) pins and EEPROMS of the 24Lxx serie.

    The problem is when i open the icprog or mplab ide, what model i have to give to the program??, i am newbie in the PICs world.

    And if you can write text in spanish, much better.
     
  2. kinjalgp

    kinjalgp Active Member

    Joined:
    Oct 28, 2002
    Messages:
    1,851
    Likes:
    3
    Location:
    INDIA/USA
    You have to specify the programmer type. ICPROG support a huge list of programmers. Check if your programmer is in the list too. If not then you can't program it uisng ICPROG.
     
  3. Skyknight

    Skyknight New Member

    Joined:
    May 1, 2003
    Messages:
    97
    Likes:
    0
    Location:
    Spain
    Sure you're using a TE 20 SE. Tell IC-Prog you have a JDM programmer. It'll work :D 8)
     

Share This Page