| | | | |
 |  |  |  |
6th October 2009, 11:20 PM
| #1 |
 hey there.
So id like to build my 1st pcb. however im not sure how to go about it. what i have to start with is (2x) 3.7v 900mah li-ion batteries. i need an output voltage of atleast 12volts to run a small project moter. with a pot to control voltage/speed is this possable | |
|
|
6th October 2009, 11:27 PM
| #2 |
|
Why not get a 6V motor and make your life much much easier?
| |
|
|
|
6th October 2009, 11:28 PM
| #3 |
|
because the motor isent actually a rotating motor its a coil setup.
| |
|
|
|
7th October 2009, 12:35 AM
| #4 |
|
Can you get hold of more batteries?
| |
|
|
 |
| Tags |
| hey |
| Thread Tools | |
| Display Modes | |
| |
Similar | ||||
| Title | Starter | Forum | Replies | Latest |
| Hey there | Op3th | Chit-Chat | 6 | 16th August 2009 09:47 PM |
| Hey What? | hjl4 | Chit-Chat | 74 | 18th March 2007 03:27 PM |
| Hey! I'm new here | METHAMPHOSiST | Chit-Chat | 14 | 7th December 2006 09:38 PM |
| hey there | bryanperito | General Electronics Chat | 1 | 17th May 2005 09:13 AM |
Linear Mode
