Basic Servo Motor doubt - Page 2 - Electronic Circuits Projects Diagrams Free

puremobi · 30th January 2009, 10:02 PM

hi..
sry for the late..
i had tried interchanging..but it din work..it still went clockwise when P3.2 = 0.
i even tried the exact value wrt 11.0592 Mhz..
most prolly my univ opens 2mrw..i will check it up there..
there must be some issue with the 1-2 ms..
if any other options...pls lemme knw...
sam

duffy · 30th January 2009, 10:22 PM

Well, that should tell you something right there. If you did that, it should be loading the OTHER timing variable and P3.2 should work the opposite way.

Try this - remove the conditional statement (the "if" clause) so that it just executes one of the timing variables all the time. Now P3.2 shouldn't make any difference. See what happens.

LALAMALIK · 6th August 2009, 10:37 AM

HELLO,
How r u.
please send me your final year project with circuit diagram,layout and other details.
u can send me other projects also with full details.
BUT I MAY WANT PROJECTS NOW IMEDIATELY.

I U WILL SEND ME NOW I WILL BE SO SO MUCH TANK FULL TO YOU.

my other E-MAIL ID SUEZMALIK@yahoo.com
YOU may have to send me on my both the E-MAIL.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
Servo motor	uaefame	Robotics Chat	41	4th December 2008 12:02 AM
Most Basic Doubt Of Digital Electronics!!!	tech_vaibhav_eee	General Electronics Chat	16	18th August 2008 04:15 AM
PIC basic and Servo Motor!	watzmann	Micro Controllers	13	22nd October 2007 01:16 AM
Need Servo And Basic Stamp Ii Help	ltmhall	Robotics Chat	15	11th October 2006 12:40 PM
DC motor, Servo Motor or Step Motor ?	wcz	Electronic Projects Design/Ideas/Reviews	1	29th June 2005 02:41 PM

30th January 2009, 10:02 PM	#16
puremobi	hi.. sry for the late.. i had tried interchanging..but it din work..it still went clockwise when P3.2 = 0. i even tried the exact value wrt 11.0592 Mhz.. most prolly my univ opens 2mrw..i will check it up there.. there must be some issue with the 1-2 ms.. if any other options...pls lemme knw... sam

30th January 2009, 10:22 PM	#17
duffy	Well, that should tell you something right there. If you did that, it should be loading the OTHER timing variable and P3.2 should work the opposite way. Try this - remove the conditional statement (the "if" clause) so that it just executes one of the timing variables all the time. Now P3.2 shouldn't make any difference. See what happens.

6th August 2009, 10:37 AM	#18
LALAMALIK	suezmalik HELLO, How r u. please send me your final year project with circuit diagram,layout and other details. u can send me other projects also with full details. BUT I MAY WANT PROJECTS NOW IMEDIATELY. I U WILL SEND ME NOW I WILL BE SO SO MUCH TANK FULL TO YOU. my other E-MAIL ID SUEZMALIK@yahoo.com YOU may have to send me on my both the E-MAIL.