rf remote transmitter and receiver - Electronic Circuits Projects Diagrams Free

koreviper · 24th October 2003, 12:38 PM

i've looked around alot for a 4 channel rf remote transmitter and receiver, but i can't find any solid leads. can anyone point me in the right direction for schematics?

anything else would be great.

thanks koreviper

brjasc · 26th November 2003, 04:27 AM

I have used some of linx wireless chips before and had no problem with them. The link on digikey is http://dkc3.digikey.com/pdf/T033/0498-0499.pdf The only hard part about using their chips is attaching it
to a circuit board. I had to solder individual wires to each pad and then
make the chip float above the board by about 1 inch.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

24th October 2003, 12:38 PM	(permalink)
koreviper	rf remote transmitter and receiver i've looked around alot for a 4 channel rf remote transmitter and receiver, but i can't find any solid leads. can anyone point me in the right direction for schematics? anything else would be great. thanks koreviper

26th November 2003, 04:27 AM	(permalink)
brjasc	rf remote transmitter and receiver I have used some of linx wireless chips before and had no problem with them. The link on digikey is http://dkc3.digikey.com/pdf/T033/0498-0499.pdf The only hard part about using their chips is attaching it to a circuit board. I had to solder individual wires to each pad and then make the chip float above the board by about 1 inch.