PWM for PIC16F877a - Electronic Circuits Projects Diagrams Free

Klitzie · 25th February 2008, 05:01 PM

Can anyone help me how to do a pwm on pic16f877a for my line follower.
A website would be a lot help. Im using a s3003 futaba for my motor. Also i have read that there is a specific motor driver when using a pwm on a motor.

blueroomelectronics · 25th February 2008, 05:51 PM

That's a servo motor, you can use PWM but it's not recommended. Wouldn't a small DC motor be better for line follower?

Mike, K8LH · 26th February 2008, 07:19 PM

How many servo channels do you need?

Klitzie · 26th February 2008, 08:08 PM

Its just for my line follower i never tried the PWM for my past porjects so now i giving it a shot, but i dont know where im going to start.

25th February 2008, 05:01 PM	(permalink)
Klitzie New Member	PWM for PIC16F877a Can anyone help me how to do a pwm on pic16f877a for my line follower. A website would be a lot help. Im using a s3003 futaba for my motor. Also i have read that there is a specific motor driver when using a pwm on a motor.

25th February 2008, 05:51 PM	(permalink)
blueroomelectronics Experienced Member Blog Entries: 4	That's a servo motor, you can use PWM but it's not recommended. Wouldn't a small DC motor be better for line follower? __________________ Bill Smart Kits build Smart People http://www.blueroomelectronics.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Latest
ADC (audio sampling) and PWM (audio playback)	MrNobody	Micro Controllers	43	20th February 2008 02:34 PM
PWM Smoothing Coding Problem	Suraj143	Micro Controllers	5	5th December 2007 04:57 AM
60 Hz PWM for RC Servo using postscaler?	ClydeCrashKop	Micro Controllers	25	5th December 2007 01:43 AM
PIC PWM outputs?	Andy1845c	Micro Controllers	33	30th November 2007 03:06 AM
PWM using software AtoD	jeremygaughan	Micro Controllers	11	27th November 2007 11:11 PM

26th February 2008, 07:19 PM	(permalink)
Mike, K8LH Experienced Member	How many servo channels do you need?

26th February 2008, 08:08 PM	(permalink)
Klitzie New Member	Its just for my line follower i never tried the PWM for my past porjects so now i giving it a shot, but i dont know where im going to start.