|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| Robotics Chat Specific to discussions about robots and the making of. |
 |
|
|
Thread Tools | Display Modes |
11th February 2008, 07:03 PM
|
(permalink) |
problem with IC PROG
i'm using ic prog to burn the hex code into my pic.but as i load the hex file into the ic prog i'm getting a warning that "the file doesnt contain a device id value".error message is coming also while verifying ....why is this due to?how can i rectify it?.....some one plz help........
|
|
|
|
|
19th February 2008, 05:56 AM
|
(permalink) |
|
You need to place the icprog.sys file in your installed directory & must enable the 95/98/NT/2000/ME/XP check box in your options tab, after these has been done restart ic prog.
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Latest |
| Problem with My A/D readings. Any suggestions? | cubdh23 | Micro Controllers | 4 | 24th September 2004 04:21 AM |
| Mysterious Problem! | matasoft | Micro Controllers | 15 | 11th September 2004 07:49 PM |
| IC Prog error :" Verify failed at address 0x0000" | G-nome | Micro Controllers | 11 | 28th January 2004 08:11 PM |
| 12F675 Problem | brodin | Micro Controllers | 10 | 29th December 2003 09:40 PM |
| strange color camera problem | schrodingerscat | Electronic Projects Design/Ideas/Reviews | 5 | 4th October 2003 07:25 PM |
Linear Mode
