Harbor Freight 8" Mini Shear Brake - Electronic Circuits Projects Diagrams Free

**3v0** · 11th September 2007, 10:20 PM

I recall that at least one other member is using one of these. Two questions.

The guide for bending slides on two rods and is held in place with two thumb screws. But the rods are free to slide in the lower bending die. How is the guide supposed to stay put once you adjust it?

What is the T-Block for?

Found this site which has the same product from several places with better manuals then the HF.
http://www.prc68.com/I/8MSB.shtml

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11th September 2007, 10:20 PM	(permalink)
3v0	Harbor Freight 8" Mini Shear Brake I recall that at least one other member is using one of these. Two questions. The guide for bending slides on two rods and is held in place with two thumb screws. But the rods are free to slide in the lower bending die. How is the guide supposed to stay put once you adjust it? What is the T-Block for? Found this site which has the same product from several places with better manuals then the HF. http://www.prc68.com/I/8MSB.shtml __________________ search engine for electronic parts Junebug USB PIC programmer kit., USB Bit Wacker, 3v0's Homepage The 15 Minute Printed Circuit Board! (+drill time)