Remote Control Help! - Electronic Circuits Projects Diagrams Free

Adz · 6th July 2003, 07:07 AM

Hey,

i need the schematics for a remote control that has 4 bottons one makes a motor go back the other forward then a nother motor that goes left and right does anyone have the schematics for a transmitter and a receiver that can do this

thankx

pttknx · 9th September 2003, 03:02 AM

it would be very helpful if you could sent this info to me as well i am makeing a vehical that drives like a tank so i need a botton for one side to move forward and backward and the same for the other any help would be greatly aprated thanks in advance

tansis · 9th September 2003, 11:07 PM

This would be a good place to start
http://www.glolab.com/encdec/mothol/mothol.html

http:/www.holtek.com
Make a range of ic's for both simple digital (on/off) and porpotional control for servo operation.

stumitch · 26th September 2003, 10:25 PM

surely the PIC can be programmed to do such a thing. one configured at 38 hz and carrier the other with a simple decoder...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

6th July 2003, 07:07 AM	#1
Adz	Remote Control Help! Hey, i need the schematics for a remote control that has 4 bottons one makes a motor go back the other forward then a nother motor that goes left and right does anyone have the schematics for a transmitter and a receiver that can do this thankx

9th September 2003, 03:02 AM	#2
pttknx	i need this as well it would be very helpful if you could sent this info to me as well i am makeing a vehical that drives like a tank so i need a botton for one side to move forward and backward and the same for the other any help would be greatly aprated thanks in advance

9th September 2003, 11:07 PM	#3
tansis	This would be a good place to start http://www.glolab.com/encdec/mothol/mothol.html http:/www.holtek.com Make a range of ic's for both simple digital (on/off) and porpotional control for servo operation.

26th September 2003, 10:25 PM	#4
stumitch	newbie remote comment surely the PIC can be programmed to do such a thing. one configured at 38 hz and carrier the other with a simple decoder...