Pic Output - cable length - Electronic Circuits Projects Diagrams Free

Wp100 · 10th October 2009, 10:34 AM

Hi,

Am outputing a signal around 10 to 50Khz from portA,0 on a 16F chip thats driving some power outputs housed in a separate enclosure.

Any suggestions as to how far away the two boxes could be without signal loss/ problems, without having to resort to signal booster ?
Am looking at 3ft max using a shielded cable

thanks.

**Nigel Goodwin** · 10th October 2009, 12:21 PM

It depends on what the receiver part is doing, but if properly designed 3 feet should be no problem.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
difference b/w normal output and open drain output of the pic	puneetnepsam	Micro Controllers	3	28th May 2009 07:50 AM
Sensing Output From Spark Plug Cable Of Petrol Engine	Achike	Electronic Projects Design/Ideas/Reviews	2	9th April 2008 12:47 PM
connect pic to 6210 with dlr-3p cable?	stu989	Micro Controllers	11	8th December 2007 08:06 AM
cable length	Thunderchild	Micro Controllers	7	1st August 2006 09:39 AM
PIC instructions length	french_student	Micro Controllers	6	19th December 2003 01:58 PM

10th October 2009, 10:34 AM	#1
Wp100	Pic Output - cable length Hi, Am outputing a signal around 10 to 50Khz from portA,0 on a 16F chip thats driving some power outputs housed in a separate enclosure. Any suggestions as to how far away the two boxes could be without signal loss/ problems, without having to resort to signal booster ? Am looking at 3ft max using a shielded cable thanks.

10th October 2009, 12:21 PM	#2
Nigel Goodwin	It depends on what the receiver part is doing, but if properly designed 3 feet should be no problem. __________________ PIC programmer software, and PIC Tutorials at: http://www.winpicprog.co.uk