|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| Micro Controllers Discuss all aspects of micro controllers - building them, coding them, etc. All controllers are welcome - PIC, BASIC, Z8 Encore!, etc. |
 |
|
|
Thread Tools | Display Modes |
10th March 2008, 01:44 PM
|
(permalink) |
please help meeeeeeeeeeeeeeeee
hi
hi everybody i need some help I am was designed the jdm programmer as shown in picture  but I have error messages as shown Programming... Erasing ("bulk" or "chip") ... Programming and Verifying CODE, 0x000000..0x00000E Verify Error: 000000: read 000000, wanted 001683 Verify Error: 000001: read 000000, wanted 003000 Verify Error: 000002: read 000000, wanted 000085 Verify Error: 000003: read 000000, wanted 001283 Verify Error: 000004: read 000000, wanted 003002 Verify Error: 000005: read 000000, wanted 000085 Verify Error: 000006: read 000000, wanted 00200B Verify Error: 000007: read 000000, wanted 003000 Verify Error: 000008: read 000000, wanted 000085 Verify Error: 000009: read 000000, wanted 00200B Verify Error: 00000A: read 000000, wanted 002804 Verify Error: 00000B: read 000000, wanted 000B88 Verify Error: 00000C: read 000000, wanted 00280B Verify Error: 00000D: read 000000, wanted 000B89 Verify Error: 00000E: read 000000, wanted 00280B Programming CONFIG, 0x002000..0x002007 Verify Error: 002007: read 000000, wanted 003FF1 ERROR: Programming FAILED ! with winpic and verify failed at data adress 0000h ! and I do not know what's wrong please help me |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
