interface with at89c51ed2 - Electronic Circuits Projects Diagrams Free

mickeystaines · 21st January 2008, 12:29 PM

hello,

i have been trying to program my at89c51ed2 micrcontroller using flip. im using the rs232-usb converter for this purpose. the flip software connects the microcontroller. however when i try to run the erase,chek,program,verify routine, it gives me a time out error. it also says cannot write to port.

m using max232n for the rs232 interface.

if not the above , then pls tell me the procedure to setup rs232 port communication. im using flip programming tool

Papabravo · 22nd January 2008, 12:58 PM

This is what will happen if there is no serial port where you think there is one or if there is something wrong with the two way connection. The timeout is what happens when FLIP sends a query to the microcontroller and gets no response. There could be many reasons for this. Did you remember to hold PSEN* low when the processor came out of RESET? If not then you are not executing the bootloader.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
Simple I2C interface chip?	oeginc	General Electronics Chat	20	29th March 2008 01:52 AM
pc I/O interface card	raus	Electronic Projects Design/Ideas/Reviews	4	30th May 2006 10:53 PM
how to interface a mechanical part with C#	parthi2929	Robotics Chat	3	15th April 2006 12:11 AM
IR computer interface	bogdanfirst	General Electronics Chat	3	24th January 2004 10:03 PM
Low-clocked microcontroller with a high-speed interface??	electronicjo	General Electronics Chat	1	18th August 2003 07:01 PM

21st January 2008, 12:29 PM	(permalink)
mickeystaines	interface with at89c51ed2 hello, i have been trying to program my at89c51ed2 micrcontroller using flip. im using the rs232-usb converter for this purpose. the flip software connects the microcontroller. however when i try to run the erase,chek,program,verify routine, it gives me a time out error. it also says cannot write to port. m using max232n for the rs232 interface. if not the above , then pls tell me the procedure to setup rs232 port communication. im using flip programming tool Last edited by mickeystaines; 21st January 2008 at 01:46 PM.

22nd January 2008, 12:58 PM	(permalink)
Papabravo	This is what will happen if there is no serial port where you think there is one or if there is something wrong with the two way connection. The timeout is what happens when FLIP sends a query to the microcontroller and gets no response. There could be many reasons for this. Did you remember to hold PSEN* low when the processor came out of RESET? If not then you are not executing the bootloader. __________________ We never have time to do it right; but we always have time to do it over.