Intermittent PIC problem - Page 2 - Electronic Circuits Projects Diagrams Free

Pommie · 3rd December 2007, 10:10 AM

Quote:

Originally Posted by eblc1388

If you enable Low Voltage Programming on the PIC, be sure to use a resistor to pull the PGM pin low.

Well spotted, that would explain his problem.
I am sure he doesn't need LVP on and would advise turning it off in the config.

Mike.

mikesmixes777 · 3rd December 2007, 01:27 PM

Perfect!!!!
I disabled the LVP and all is good. Thanks for all the advice and help.

Now with this fixed I can move forward and advance my program to do ADC and RS232 comms.

I'll try not be, but I'm sure i'll be back....

Thanks Again.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
PIC16F877A charging problem	eleceyes	Micro Controllers	6	22nd November 2007 08:06 AM
Problems switchin relay with PIC	Andy1845c	General Electronics Chat	5	17th November 2007 07:14 PM
PIC pin to MOSFET gate problem	Futterama	Electronic Projects Design/Ideas/Reviews	7	8th November 2007 06:31 PM
I think I gave PIC 12V instead of 5V	kavelot	General Electronics Chat	3	5th November 2007 06:04 PM
strange color camera problem	schrodingerscat	Electronic Projects Design/Ideas/Reviews	5	4th October 2003 08:25 PM

3rd December 2007, 01:27 PM	(permalink)
mikesmixes777	Perfect!!!! I disabled the LVP and all is good. Thanks for all the advice and help. Now with this fixed I can move forward and advance my program to do ADC and RS232 comms. I'll try not be, but I'm sure i'll be back.... Thanks Again.