Hi all,
I am making a project in which i will have a temperature sensor with a programed microcontroler and I also want that it would be connected both to the LCD and to PC.

Now I am very interested in how could I connect microcontroler to the PC, should i use USB, serial ports or .... ?


Please anyone, if you have any comments or suggestions please write them to me.

Than you!!!!

 

You might try reading the 'sticky' at the top of this forum, and check my tutorials!.

__________________
PIC programmer software, and PIC Tutorials at:
http://www.winpicprog.co.uk

 

Yeee, I allready have the programmer PIC2kit , i will have the microcontroller programed and tested , but I need some info about connecting it to the PC and any suggestions how could I make it. Please give me your ideas. Because I am running low on them now(((

 

Like I said above - read my tutorials, which show how to do everything you need!.

__________________
PIC programmer software, and PIC Tutorials at:
http://www.winpicprog.co.uk

 

Ok, thanx for the tutorials.
But could you please just answer few questions:
1.If i will have the program written in a microcontroler to show the temperature from my temperature sensor on an LCD, how should i make the same things to be showen in my PC's monitor ? Thank you ))

 

Tutorial 11.4 - why don't you just go and look?.

__________________
PIC programmer software, and PIC Tutorials at:
http://www.winpicprog.co.uk

 

It is because I am lol and I can not find it ((((

 

Use SERIAL comms, a MAX232 level shifter and (sorry Nigel!! ) PicBasic!

__________________
====
Shax.
====

A bus station is where a bus stops...
A train station is where a train stops...
On my desk I have a work station...
Nuff Sed!!!