|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| Micro Controllers Discuss all aspects of micro controllers - building them, coding them, etc. All controllers are welcome - PIC, BASIC, Z8 Encore!, etc. |
 |
|
|
Thread Tools | Display Modes |
3rd October 2007, 07:43 PM
|
(permalink) |
Connecting Motor
I finally got my L297/L298 circuit up and running... the voltages on the outputs alternate between 12V (Vs) and 0V..
But when i connect the motor.. it doesn't rotate =/ I connect one winding to OUT1 and OUT2 and the other to OUT3 and OUT4.. is it correct? (its a 2-phase Bipolar Stepper) Also What should i set the Reset on the L297 to? Lots of Thanks in Advance for any help Regards Baber Javed |
|
|
|
|
3rd October 2007, 08:14 PM
|
(permalink) |
|
Thanks Guy... my Mistake.. its rotating but very slow! =)
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Latest |
| Project: DC Motor Control (using a single switch) | arijit18 | Electronic Projects | 12 | 2nd September 2008 07:51 PM |
| Motor Controllers and serial comm? | RedCore | Micro Controllers | 18 | 3rd July 2007 01:27 AM |
| Motor Position Control Problem | YAN-1 | Electronic Projects Design/Ideas/Reviews | 10 | 31st March 2006 02:02 PM |
| Connecting an electrial motor | TKS | General Electronics Chat | 10 | 9th June 2005 11:24 AM |
| Connecting 240 volts to a motor | Anonymous | Electronic Projects Design/Ideas/Reviews | 8 | 26th September 2002 03:37 PM |
Linear Mode
