![]() | ![]() | ![]() |
| | |||||||
| Micro Controllers Discuss all aspects of micro controllers - building them, coding them, etc. All controllers are welcome - PIC, BASIC, Z8 Encore!, etc. |
| | Thread Tools | Display Modes |
| | (permalink) |
| New Member | I am doing the above project with 8051 microcontroller, but i have done it with AVR microcontroller. I have the following doubts. 1. which Nokia models obey AT command 2. which Nokia models obey FBUS protocol Anybody knows |
| | |
| | (permalink) |
| Experienced Member | For FBUS consider using the older phones like nokia 3310, 5110, 6110, and 3210
__________________ People perish because of lack of knowledge |
| | |
| | (permalink) |
| Experienced Member | You might find some helpful information for your project in the SMS Controller featured in the Silicone Chip AU online magazine - also available as a kit from Jaycar. |
| | |
| | (permalink) |
| Experienced Member | |
| | |
| | (permalink) |
| Experienced Member | older versions of nokia uses.. Fbus and mbus.. well.. i am little in this knowledge.. but i am sure that sony-erricson phone uses AT Commands.. Regards, Simran..
__________________ Simran.. 8051 Specialist.. |
| | |
| | (permalink) |
| New Member | Check out this page for a tutorial on FBUS for nokia phones www.ucdevelopers.page.tl |
| | |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
| | ||||
| Thread | Thread Starter | Forum | Replies | Latest |
| Controlling devices through mobile phone | tkvenki | Electronic Projects Design/Ideas/Reviews | 7 | 24th May 2007 12:10 PM |
| controlling mobile phone using microcontroller | froten | Micro Controllers | 7 | 8th July 2006 03:55 AM |
| controlling mobile phone using microcontroller | froten | Electronic Projects Design/Ideas/Reviews | 8 | 5th July 2006 10:08 PM |
| Mobile phone related question | waynefeltham | Electronic Projects Design/Ideas/Reviews | 16 | 22nd September 2003 09:05 AM |
| Mobile Phone Sensor | tim_l_012 | Electronic Projects Design/Ideas/Reviews | 0 | 21st June 2003 11:49 AM |