A/D Values - Electronic Circuits Projects Diagrams Free

Omar.M · 16th April 2007, 10:56 PM

Hello!
I'm building a line follower, as some of you may know and I'm having troubles with the one Cds sensor. With my multimeter, I get about ~.8 V off the line and ~2 V on the line. When I finished my program / robot building and tested it out, it doesn't work.
Now, I've gone through the code for a few days now, pretty much got rid of anything not needed and all that I can point my finger towards is the AD values.

So I was wondering, what values would the PIC see from the AD port... would they be any different than above?
Thanks!

I would like to add that I am programming in BASIC (Great Cow Basic http://gcbasic.sourceforge.net/)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
Using Oscilloscopes	mechie	Electronic Theory	9	29th November 2007 10:49 PM
PIC A/D Sampling multiple inputs	NJ Roadmap	Micro Controllers	10	21st February 2007 02:54 AM
help with a/d 0808	bakaborta	Micro Controllers	0	11th February 2007 02:28 PM
Caps - trying to get all values in the series	atferrari	Datasheet/Parts Requests	7	17th December 2006 10:19 AM
Resistor values......	madmikejt12	General Electronics Chat	12	11th October 2005 04:12 PM

16th April 2007, 10:56 PM	#1
Omar.M	A/D Values Hello! I'm building a line follower, as some of you may know and I'm having troubles with the one Cds sensor. With my multimeter, I get about ~.8 V off the line and ~2 V on the line. When I finished my program / robot building and tested it out, it doesn't work. Now, I've gone through the code for a few days now, pretty much got rid of anything not needed and all that I can point my finger towards is the AD values. So I was wondering, what values would the PIC see from the AD port... would they be any different than above? Thanks! I would like to add that I am programming in BASIC (Great Cow Basic http://gcbasic.sourceforge.net/) Last edited by Omar.M; 17th April 2007 at 12:21 AM.