STK500 and Tiny11 programming problem. - Electronic Circuits Projects Diagrams Free

mramos1 · 8th May 2006, 02:57 PM

I just bought some Tiny11 ship, was so excited. Ported a program over to it. Got out the manual and find it is Serial High Voltage programming. Assume that is 12V on it. Anyway. I jumpered the board per the manual and no go.

Running 3.55 of the AVR software, pulled 4.0 to try tonight. Anyone think of something obvious? Or have a simple Tiny11 programmer. I have looked at two, but figure I own a $$$ one.. Like to use it.

Can can not read the signature on the chip, it defaults to disable future programming on the chip.. I do 2313, 1200 and mega8 all the time with parallel high voltage.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

8th May 2006, 02:57 PM	(permalink)
mramos1	STK500 and Tiny11 programming problem. I just bought some Tiny11 ship, was so excited. Ported a program over to it. Got out the manual and find it is Serial High Voltage programming. Assume that is 12V on it. Anyway. I jumpered the board per the manual and no go. Running 3.55 of the AVR software, pulled 4.0 to try tonight. Anyone think of something obvious? Or have a simple Tiny11 programmer. I have looked at two, but figure I own a $$$ one.. Like to use it. Can can not read the signature on the chip, it defaults to disable future programming on the chip.. I do 2313, 1200 and mega8 all the time with parallel high voltage.