| | | | |
 |  |  |  |
| |||||||
| Micro Controllers Discuss all aspects of micro controllers - building them, coding them, etc. All controllers are welcome - PIC, BASIC, Z8 Encore!, etc. |
 |
| | Tools |
21st March 2006, 11:17 AM
| #1 |
 JDM on ICPROG
Hi, I made jdm programmer and when I try with icprog I recieve message :NO ACKNOWLEDGE RECIEVE. Please help me where is the problem, and how can I measure voltage on my com port and what value I can expect, best regards | |
|
|
21st March 2006, 01:52 PM
| #2 | |
| Re: JDM on ICPROG Quote:
make sure u have selected correct settings in the icprog which ckt u used for jdm?
__________________ Gods own Country Incredible !ndia www.flickr.com/photos/_akg/ "Give a man a fish, and he will eat for a day. Teach that man to fish, and he will eat for a lifetime." | ||
|
|
|
22nd March 2006, 07:53 AM
| #3 |
| JDM
What is ckt?, regards | |
|
|
|
22nd March 2006, 08:57 AM
| #4 | |
| Re: JDM Quote:
__________________ Gods own Country Incredible !ndia www.flickr.com/photos/_akg/ "Give a man a fish, and he will eat for a day. Teach that man to fish, and he will eat for a lifetime." | ||
|
|
|
22nd March 2006, 10:02 AM
| #5 |
| Hi JDM circuit diagram
Hi, circuit diagram is attached, regards
| |
|
|
|
22nd March 2006, 10:06 AM
| #6 |
| attached not work I replay
Because attach not work before I do again
| |
|
|
|
22nd March 2006, 09:05 PM
| #7 |
| Hi again
Hi, I measure voltage from hardware check option from ICprog and I have all voltage but when I enable clock all other voltage for example mclr drop from 13,7 to 8 V. What is the problem, regards | |
|
|
| |
| Tags |
| icprog, jdm |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
