+ Reply to Thread
Results 1 to 2 of 2

Thread: ICD2 Clone with MPLAB 7.30?

  1. 24th December 2005 07:58 PM #1
    Mike, K8LH
    Mike, K8LH is offline
    Mike, K8LH Excellent Mike, K8LH Excellent Mike, K8LH Excellent Mike, K8LH Excellent Mike, K8LH Excellent Mike, K8LH Excellent Mike, K8LH Excellent
    Join Date
    Jan 2005
    Location
    Michigan, USA
    Posts
    2,522

    Default ICD2 Clone with MPLAB 7.30?

    Just upgraded from MPLAB 7.21 to MPLAB 7.30 and noticed that my ICD2 clone fails the self test on the VPP voltage but I actually have the same 12.96 volts VPP voltage that I had before... Interestingly, it still programs and verifies devices ok, despite the "failed self test" message... Has anyone else noticed this? Is this a minor change in the VPP limit checking in MPLAB 7.30?

    TIA... Happy Holidays... Regards, Mike
    Reply With Quote Reply With Quote  

  2. 24th December 2005 09:18 PM #2
    Jay.slovak
    Jay.slovak is offline
    Super Moderator Jay.slovak Good Jay.slovak Good Jay.slovak Good
    Join Date
    Jan 2005
    Location
    Slovakia
    Posts
    1,740

    Default

    Hi Mike,

    So far, My ICD2 is working just fine with MPLAB 7.30 (tested with 10F206 and 18F2620). My Vpp is 13.02 V.
    Try to reinstal MPLAB and/or to rise your VPP voltage a bit.

    Mary X-mas.
    "I share, thus I am"
    Jay.slovak
    Read this!
    ICD2 Clone
    Best PIC/DsPIC Bootloader

    Read my Inchworm ICD2 review!
    Reply With Quote Reply With Quote  
+ Reply to Thread
« Previous Thread | Need a hand using my ICD2 »

Tags for this Thread