24th April 2012 11:15 PM
hello this is a automatic isolation switch please help
hello( sorry but i dont know very good english )i have this constuctDSC_0053.JPGDSC_0045.JPG DSC_0046.JPGand i must do the schematic of the circuit ,i tried but i dont know if its right??????.JPG the brown wire start from the big capacitor and i dont know were it goes its in the air... i appreciate if someone knows where goes the brown wire and help me to analyse this circuit thank you vety much
25th April 2012 05:01 AM
In my Knowledge i will suggest you to use Digital Multimeter(DMM) in continuity mode if your task is to draw the Schematics from the Layout (Assembled board), First of all we should know where are those wires are soldered with Black cable (if i'm right)?
Secondly the end of brown wire may go through a PTH(Plated Through Hole) so at the bottom side of the board u probe with DMM for continuity.
25th April 2012 07:54 AM
Thank you ssundar.shan for replay this is another from distance photo DSC_0615.JPG
Electronic Circuits |
Page Time: 0.04682 seconds Memory: 7,212 KB Queries: 17 Templates: 0