HI,

Is there any way to shift dc level(below 0 or beyond) of an ac signal. I diode clamping does not fulfill my need as it limits at +0.7 volts.
thanx

 

hi,
Depending upon the 'ac signal' you could use a OPA to give a 'dc' offset to the 'ac' signal.

Give us more information.

__________________
Eric " Good enough is Perfect "
I will NOT answer PM's requesting technical help, please use the Forum
PIC tutorials: Nigel's www.winpicprog.co.uk/ Bill's: www.blueroomelectronics.com/

 

A common method is to couple the AC signal through a capacitor. The DC level at the output of the cap can be shifted to whatever you want with a resistor to the desired bias voltage. The RC time constant of the capacitor and resistor has to be large enough to transfer the lowest AC frequency of interest, of course.

__________________
Carl
Curmudgeon Elektroniker

 

Recently i was engaged in making desired figures on cro.There also i needed dc shift in ac signal.I directly added ac & necessary dc voltage using resistors and this seem to work fine.

 

I am using single supply and the signal is 6MHz sinewave. The oscillator is the part of that circuit