Orcad Layout to Corel Draw - Electronic Circuits Projects Diagrams Free

premkumar9 · 15th January 2009, 11:24 AM

Hi,
Can anybody please tell me how single sided PCB layout prepared using Orcad can be transferred to Corel DRAW.

dknguyen · 15th January 2009, 02:25 PM

Try using the gerber tool.

premkumar9 · 16th January 2009, 05:38 AM

I think there is no problem in pulling down the O/P pin of 89C2051 to ground through a push switch (as it has a built in pull up resistor at this point which will limit the current). Am I right?

premkumar9 · 16th January 2009, 05:47 AM

Quote:

Originally Posted by premkumar9

I think there is no problem in pulling down the O/P pin of 89C2051 to ground through a push switch (as it has a built in pull up resistor at this point which will limit the current). Am I right?

I mean as the microcontroller has a pull up resistor.

universal1 · 5th April 2009, 12:28 PM

you can make this by creating gerber file from orcad then use gbr to bmp program to give you the bmp file then you can take it by corel

premkumar9 · 5th April 2009, 12:55 PM

Quote:

Originally Posted by universal1

you can make this by creating gerber file from orcad then use gbr to bmp program to give you the bmp file then you can take it by corel

I did it by making prn file which I could open in Corel.

duffy · 5th April 2009, 02:14 PM

With the internal pull-up resistors the switch should not be a problem.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
OrCAD PCB Editor vs Layout	dknguyen	Chit-Chat	3	1st January 2007 05:28 AM
What software do you use to draw sch and PCB layout?	Alex_rcpilot	General Electronics Chat	11	24th July 2005 08:13 PM
Someone draw me this in Eagle please	SQLException	Electronic Projects Design/Ideas/Reviews	2	20th January 2005 11:03 PM
Can someone Draw the schematic for this picture?	shuluke	Electronic Projects Design/Ideas/Reviews	14	15th June 2004 11:45 PM
Orcad PCB Layout Manual Guide, Help !	sinkopa	General Electronics Chat	1	31st March 2004 10:20 AM

15th January 2009, 11:24 AM	#1
premkumar9	Orcad Layout to Corel Draw Hi, Can anybody please tell me how single sided PCB layout prepared using Orcad can be transferred to Corel DRAW.

15th January 2009, 02:25 PM	#2
dknguyen	Try using the gerber tool.

16th January 2009, 05:38 AM	#3
premkumar9	I think there is no problem in pulling down the O/P pin of 89C2051 to ground through a push switch (as it has a built in pull up resistor at this point which will limit the current). Am I right? Attached Thumbnails

5th April 2009, 12:28 PM	#5
universal1	you can make this by creating gerber file from orcad then use gbr to bmp program to give you the bmp file then you can take it by corel

5th April 2009, 02:14 PM	#7
duffy	With the internal pull-up resistors the switch should not be a problem.