Driving our full bridge inverter - Electronic Circuits Projects Diagrams Free

kken6248 · 2nd April 2004, 03:23 AM

We are trying to drive our full bridge inverter with a mosfet driver (HIP4082) connected to a SG3525 PWM chip. For some reason I think the frequency @ 60 Hz coming out of the Sg3525 is too low and the sync pin (Sg3525) may be acting differently then we want it to. We are trying to produce a 60 HZ sine wave. Any possible suggestions that can help me?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

2nd April 2004, 03:23 AM	#1
kken6248	Driving our full bridge inverter We are trying to drive our full bridge inverter with a mosfet driver (HIP4082) connected to a SG3525 PWM chip. For some reason I think the frequency @ 60 Hz coming out of the Sg3525 is too low and the sync pin (Sg3525) may be acting differently then we want it to. We are trying to produce a 60 HZ sine wave. Any possible suggestions that can help me?