I'm a newbie to the world of load cells .... I want to know the meaning of the following parameters of load cells :

1- zero balance
2-creep error
3-sealing

also I want to know the following

The unit of the related output is mv/v
I know the mv ... but what is the meaning of the v

 

When there is no load on the load cell, there will be some output, ideally the output should be zero. The output at zero load is the zero balance error.

The output can change over time, probably while the cell is loaded. This is the creep error.

How well the device keeps out water/oil/whatever.

The cell is almost certainly a strain gauge bridge.
The output when loaded will be so many milli-volts for each volt of bridge excitation supply.
Hence mv/V.

JimB

__________________
Experience is directly proportional to the value of the equipment ruined.

 

thank you very much ... that's all what I hoped