Multimeter - Electronic Circuits Projects Diagrams Free

AxelD · 26th August 2008, 03:13 PM

Hi,

My next project is around IR circuits so i was thinking of getting a multimeter with a frequency function. Is this function any use and how does this differ from a o-scope?

Thanks

crutschow · 26th August 2008, 03:56 PM

A multimeter will give a digital readout of the frequency only. An o-scope shows a picture of the waveform (from which you can derive the frequency from the waverform period). An o-scope is a much more versitile instrument than a multimeter (and generally considerably more expensive). Many digital o-scopes also give a digital readout of the frequency.

rezer · 26th August 2008, 04:47 PM

Also, most DMMs bandwidth is quite small compared to most o-scopes on the market. For instance, my Meterman 37XR as a bandwidth of 10MHz, priced for around $125.00. You can by a scope with 10Mhz bandwidth fairly cheap in todays market and still get the benefit of analyzing the waveform. You don't get this with a DMM unless it has an LCD screen, it which case you might as well use a scope for the price you would pay. Depending on the type of work you are doing and the clock speeds involved will determine the bandwidth of the scope that you need. But I would definitely use a scope versus a multi-meter for measuring frequency because of the added visual benefit. Unless you don't care what the signal looks like

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
multimeter use	gerryw	General Electronics Chat	22	11th November 2007 02:49 PM
Multimeter	irisd	General Electronics Chat	7	7th November 2007 01:12 PM
multimeter help	nuttaphong191	General Electronics Chat	2	31st July 2007 06:49 PM
Multimeter	Dr.EM	Chit-Chat	13	2nd September 2005 07:00 PM
Do you have an multimeter?	Someone Electro	Chit-Chat	16	14th August 2005 08:23 PM

26th August 2008, 03:13 PM	(permalink)
AxelD	Multimeter Hi, My next project is around IR circuits so i was thinking of getting a multimeter with a frequency function. Is this function any use and how does this differ from a o-scope? Thanks

26th August 2008, 03:56 PM	(permalink)
crutschow	A multimeter will give a digital readout of the frequency only. An o-scope shows a picture of the waveform (from which you can derive the frequency from the waverform period). An o-scope is a much more versitile instrument than a multimeter (and generally considerably more expensive). Many digital o-scopes also give a digital readout of the frequency. __________________ Carl

26th August 2008, 04:47 PM	(permalink)
rezer	Also, most DMMs bandwidth is quite small compared to most o-scopes on the market. For instance, my Meterman 37XR as a bandwidth of 10MHz, priced for around $125.00. You can by a scope with 10Mhz bandwidth fairly cheap in todays market and still get the benefit of analyzing the waveform. You don't get this with a DMM unless it has an LCD screen, it which case you might as well use a scope for the price you would pay. Depending on the type of work you are doing and the clock speeds involved will determine the bandwidth of the scope that you need. But I would definitely use a scope versus a multi-meter for measuring frequency because of the added visual benefit. Unless you don't care what the signal looks like __________________ "Remember, you're special.....just like everyone else."