|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| General Electronics Chat This forum is for general chat about electronics, eg: Dont know what a part does? Dont know how to read a circuit? Want to get an opinion? |
 |
|
|
Thread Tools | Display Modes |
1st July 2007, 01:48 PM
|
(permalink) |
simulation problem using programming editor 5.1.1
hi when i run my program in the simulation after a little while it just stops on a if...then gosub... still as if it was running it has all the boxes open and the yellow background is it something to do with my code thanks...
i am not going to put up the symbol names for variables as they shouldnt be needed to figure this out as it will be a code problem. a quick thing telling what my code does its a game you have two paddles and a ball which you bat around when you miss you get a point first to three wins it is played on a 7x8 dot matrix using a picaxe 28x1 thanks any help will be great ps. it always stops in the pong: heading thanks alot danny Last edited by danny009; 1st July 2007 at 01:57 PM. |
|
|
|
|
1st July 2007, 04:13 PM
|
(permalink) |
its ok all silly me i was just looking at the gosub commands and i a saw that sometimes i have a over 4 gosubs( one within each other) which cannot happen with the picaxe 28x1
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Latest |
| Help with problem programming 16F628A | ukatv | Micro Controllers | 8 | 25th September 2007 08:23 PM |
| Standalone Pic Programmer Using ICSP or RS232 | Neiwiertz | Micro Controllers | 11 | 27th May 2006 01:22 AM |
| Big thermocouple ADC problem | Oznog | General Electronics Chat | 9 | 4th May 2004 08:42 PM |
| problem with programming 89c2051 ! | hm_fa_da | Micro Controllers | 1 | 3rd May 2003 01:13 PM |
| problem of programming pic16f84a | Byron Yau | Micro Controllers | 15 | 19th April 2003 05:09 PM |
Linear Mode
