Remote mounted LCD screen - Electronic Circuits Projects Diagrams Free

Aja · 16th May 2007, 11:52 AM

Hello all, im knew to the forum, and also knew to electronics. I am hoping to get some advice on how i might remove the lcd from the cell phone case, while still remaining electrically connected. essentially i want to make a model of a videogame setup, the phone itself will be incase inside the model, and te lcd screen will look like a monitor when im done. i will import custom animations onto the phone. so what im looking to do is basically lengthen the lcd connections and ribbon cable. any suggestions?

Gayan Soyza · 16th May 2007, 12:06 PM

open the both side cases & remove the battery in the phone & remove it from a hot iron (soldering) gun.
If the LCD has a lock type connector just remove the clip.

Thats all.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
music database/transmission system	cyprio7	Electronic Projects Design/Ideas/Reviews	0	26th April 2007 04:54 PM
89c4051 4-bit controlled LCD sporadic screwup	Pax Writer	Micro Controllers	7	26th April 2007 06:58 AM
Tring to build an infrared remote control...need help	homemade	Electronic Projects Design/Ideas/Reviews	1	19th March 2004 09:44 AM
Making a remote LCD screen for a computer!!	Squiggles	Electronic Projects Design/Ideas/Reviews	5	14th March 2004 09:41 PM
Remote Keyless Entry for Car	tim_l_012	General Electronics Chat	4	23rd February 2004 12:38 AM

16th May 2007, 11:52 AM	(permalink)
Aja	Remote mounted LCD screen Hello all, im knew to the forum, and also knew to electronics. I am hoping to get some advice on how i might remove the lcd from the cell phone case, while still remaining electrically connected. essentially i want to make a model of a videogame setup, the phone itself will be incase inside the model, and te lcd screen will look like a monitor when im done. i will import custom animations onto the phone. so what im looking to do is basically lengthen the lcd connections and ribbon cable. any suggestions?

16th May 2007, 12:06 PM	(permalink)
Gayan Soyza	open the both side cases & remove the battery in the phone & remove it from a hot iron (soldering) gun. If the LCD has a lock type connector just remove the clip. Thats all. __________________ Gayan My Website http://gsmicro.blogspot.com/ Last edited by Gayan Soyza; 16th May 2007 at 12:08 PM.