On my can of photo resist spray, it says this:
Drying time:
20 degrees c/24hr
70 degrees c/20min

does this mean that i can put the pcb in the oven?
apologies if this is a stupid question.

thanks

 

If you can get the oven to 70 degrees then fine. A fan oven is best. A warning, though, wives and mothers can be unreasonable about this use of the kitchen appliances.

 

My girlfriend doesnt like to cook, so i doubt she'd get touchy about it.

thanks

 

hi bitem,

You could try using your girl friends 'hair dryer', they work quite well.

Useful for heat stress check on pcb's , keep heat level less than 70degC, set for low heat, with short blasts.

Regards
EricG

 

cool thanks