traxmaker PCB design - Electronic Circuits Projects Diagrams Free

p1120 · 2nd September 2006, 04:05 PM

Hi everyone
I am a beginner in using traxmaker .Can anyone please tell me whether in designing a PCB in traxmaker,does it matter if 2 tracks cross eachother?If yes,would putting these tracks on separate layers overcome the problem?

dknguyen · 2nd September 2006, 08:28 PM

Usually the software has a dot where crossing traces actually intersect. It gets way too messy if the software makes it so that non-connected tracks never intersect. This is for the electrical schematic only that shows the electrical connections. In the layout stage (where you physically organize the PCB, it does matter and putting it on separate layers INTELLIGENTLY will help).

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

2nd September 2006, 04:05 PM	(permalink)
p1120	traxmaker PCB design Hi everyone I am a beginner in using traxmaker .Can anyone please tell me whether in designing a PCB in traxmaker,does it matter if 2 tracks cross eachother?If yes,would putting these tracks on separate layers overcome the problem?

2nd September 2006, 08:28 PM	(permalink)
dknguyen	Usually the software has a dot where crossing traces actually intersect. It gets way too messy if the software makes it so that non-connected tracks never intersect. This is for the electrical schematic only that shows the electrical connections. In the layout stage (where you physically organize the PCB, it does matter and putting it on separate layers INTELLIGENTLY will help).