|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| General Electronics Chat This forum is for general chat about electronics, eg: Dont know what a part does? Dont know how to read a circuit? Want to get an opinion? |
 |
|
|
Thread Tools | Display Modes |
27th February 2005, 02:46 PM
|
(permalink) |
which is the best? pcb layout???
mates, what is the best among this two. orcad or eagle? why?
|
|
|
|
|
28th February 2005, 02:06 AM
|
(permalink) |
|
Never used Orcad, but I can say Eagle's easy to use, cheap, and easy to get ahold of. The autorouter is fairly smart. It's got a lot of annyoing quirks in the way libraries are managed that can screw you over if you don't start out using tricks to manage the libraries from the beginning. But otherwise it gets the job done and does it fairly well.
|
|
|
|
|
|
28th February 2005, 03:23 AM
|
(permalink) |
|
I've never used orcad either, but that's because i've never felt the need to since I like eagle so much. perhaps that says something :wink:
__________________
EEgeek.net |
|
|
|
|
Linear Mode
