hi gang.

is there a way to 'force' eagle 4.11r2 to do a single layer layout?

i have a board with only 2 ic's and an transistor, but eagle insists on making it a 2 layer board, which i can't etch at home!

i went into the drc setup and set layer setup to 1, but it looks like it's still doing 2 layers, as there are red and blue traces on the screen

any thoughts are appericated!

 

In the Autorouter setup, under the "General" tab, set the preferred direction of the top layer (layer 1) to "N/A". That should do the trick 8)

 

thanks!