Preview not working - Electronic Circuits Projects Diagrams Free

kenmac · 21st September 2004, 04:51 AM

Hi,
I have just submitted a new topic in the Microcontrollers forum, and encountered a problem with Preview.
Before submitting, when I asked for a Preview, it just displayed the subject line with no message.
I tried a couple of times, but same result.

kenmac

**Nigel Goodwin** · 21st September 2004, 08:09 AM

Quote:

Originally Posted by kenmac

Hi,
I have just submitted a new topic in the Microcontrollers forum, and encountered a problem with Preview.
Before submitting, when I asked for a Preview, it just displayed the subject line with no message.
I tried a couple of times, but same result.

Have you tried reading the thread just two lines below?, with exactly the same title!.

kenmac · 21st September 2004, 08:33 AM

Nigel,
It only displays one line: " Posted: ....etc"
You can see one line of darker grey but no message.

kenmac

samcheetah · 21st September 2004, 12:37 PM

actually Nigel is telling u that this topic has already in discussion. if i remember properly a user Ron_H started the same topic. have a look at that thread.

kenmac · 21st September 2004, 12:45 PM

OK, thanks.

kenmac

**ElectroMaster** · 8th October 2004, 10:02 PM

This problem has been resolved.

Please refer to the following thread:

http://www.electro-tech-online.com/v...ic.php?t=11466

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

21st September 2004, 04:51 AM	(permalink)
kenmac	Preview not working Hi, I have just submitted a new topic in the Microcontrollers forum, and encountered a problem with Preview. Before submitting, when I asked for a Preview, it just displayed the subject line with no message. I tried a couple of times, but same result. kenmac

21st September 2004, 08:33 AM	(permalink)
kenmac	Preview not working Nigel, It only displays one line: " Posted: ....etc" You can see one line of darker grey but no message. kenmac

21st September 2004, 12:37 PM	(permalink)
samcheetah	actually Nigel is telling u that this topic has already in discussion. if i remember properly a user Ron_H started the same topic. have a look at that thread.

21st September 2004, 12:45 PM	(permalink)
kenmac	OK, thanks. kenmac

8th October 2004, 10:02 PM	(permalink)
ElectroMaster	This problem has been resolved. Please refer to the following thread: http://www.electro-tech-online.com/v...ic.php?t=11466 __________________ ▌ Electro Tech Online Owner ▌ Need to contact me? Send me a Private Message. ▌ Verification Email didn't arrive? See this thread.