Hi i need to design a BJT amplifier circuit
and these are the specification i need to follow

The amplifier described in this specification should operate from a single 15-volt supply and have a small signal voltage gain of your choice between 10 dB and 20dB.

The amplifier uses voltage divider bias and has a load resistance of 10k-ohms.

I am thinking to build it on a vero board or a breadboard.
Thanks for your help

 

hi,
I'm not sure what you are asking for.?

__________________
Eric " Good enough is Perfect "
I will NOT answer PM's requesting technical help, please use the Forum
PIC tutorials: Nigel's www.winpicprog.co.uk/ Bill's: www.blueroomelectronics.com/

 

I have no idea how to design this. i need help on how i am going to design the BJT amplifier

 

hi,
I see, OK.
May I ask if this is classwork.

Look thru this collection and post your design.

Transistor circuits, transistor as amplifiers, BJT, bipolar junction transistor, Miller effect

__________________
Eric " Good enough is Perfect "
I will NOT answer PM's requesting technical help, please use the Forum
PIC tutorials: Nigel's www.winpicprog.co.uk/ Bill's: www.blueroomelectronics.com/

 

You should give a few more details such as frequency range.There are a number of approaches for that.You may use 1/10 rule which assumes Ve=(1/10)*Vcc.Draw the dc equivalent of voltage divider bias.We have different models for different frequency ranges.You can find them in any of the electronics book.