What's problem with auto of funtion of the Orcad - Electronic Circuits Projects Diagrams Free

hoangson · 19th February 2009, 12:54 PM

I use Orcad version 10.0 everything seems well but.. I don't know the erroring .. when I complete a board.. and exit from Orcad programe
. that's oke however If i want to adjust this board by unround command and replace some components then I run the auto funtion of round It doesn't allow to auto run again ??? I don't know why ?? unless I have to use the neslist file and arrrange the component then do It's oke !! I send a picture that describle my problem.. I hope You will show me why ?? thanks

duffy · 19th February 2009, 01:27 PM

Try re-loading the strategy file (*.sf) - it's under File -> Load. Sometimes that will get it out of that mode where it says "all sweeps complete or disabled" and won't autoroute.

hoangson · 21st February 2009, 05:47 AM

Quote:

Originally Posted by duffy

Try re-loading the strategy file (*.sf) - it's under File -> Load. Sometimes that will get it out of that mode where it says "all sweeps complete or disabled" and won't autoroute.

thansk duffy, i will try

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
I Need Help...where Can I Get The Circuit Of Funtion Generator	tek_.	Electronic Projects Design/Ideas/Reviews	6	19th August 2006 11:25 AM
Problem simulating with Orcad 9.2	supernova	Electronic Projects Design/Ideas/Reviews	2	9th July 2005 01:57 PM
i have Problem on Orcad. need help~~~~	wontall	General Electronics Chat	1	7th May 2004 08:39 PM
Iam really in big PCB design problem under Orcad Suite 9.2	wissam	Electronic Projects Design/Ideas/Reviews	0	1st March 2004 07:11 PM
problem in smulaiting (8086) using orcad 9.2	massoti	General Electronics Chat	16	23rd February 2003 05:53 PM

19th February 2009, 12:54 PM	#1
hoangson	What's problem with auto of funtion of the Orcad I use Orcad version 10.0 everything seems well but.. I don't know the erroring .. when I complete a board.. and exit from Orcad programe . that's oke however If i want to adjust this board by unround command and replace some components then I run the auto funtion of round It doesn't allow to auto run again ??? I don't know why ?? unless I have to use the neslist file and arrrange the component then do It's oke !! I send a picture that describle my problem.. I hope You will show me why ?? thanks Attached Thumbnails Last edited by hoangson; 19th February 2009 at 12:56 PM.

19th February 2009, 01:27 PM	#2
duffy	Try re-loading the strategy file (*.sf) - it's under File -> Load. Sometimes that will get it out of that mode where it says "all sweeps complete or disabled" and won't autoroute.