Hello all! First post here.

I have a stepper motor driver IC that I scavenged out of a copier. I want to use it to drive a unipolar stepper motor. I found the pinout data sheet, but I'm kind of clueless on how to connect it such that I have a single clocked input that steps the motor, and another input that toggles the motor direction.

The IC is an MTD1361F. Here is the data sheet I found:http://www.datasheetcatalog.org/data...en/mXstzrr.pdf

Any help is appreciated.

the short answer is that you can't.

the long answer is this circuit: Stepper Motor Controller