Digital Logic testing - Electronic Circuits Projects Diagrams Free

jacks · 30th October 2008, 12:18 PM

Friends

I want to test an 8 bit packet for errors i.e address and instruction/data of the packet. I am thinking serial to parallel shift register and the output exclusive ORed, back to the input of serial. How can I test the address and instruction data? If the packet is okay I want it to go turn a motor on a H-Bridge packet, is this possible? Probably use a DA converter. Thanks

Jacks

**Nigel Goodwin** · 30th October 2008, 12:33 PM

Do in a processor, a PIC would be suitable - and almost a single chip solution to the entire design.

jacks · 30th October 2008, 12:51 PM

Nigel

Thanks for your response. How will I test it on a PIC? Is there a programming language I will have to learn? Thanks

Jacks

**Nigel Goodwin** · 30th October 2008, 01:08 PM

Quote:

Originally Posted by jacks

Nigel

Thanks for your response. How will I test it on a PIC? Is there a programming language I will have to learn? Thanks

Yes you need to learn to program the PIC, assembler, C or BASIC are the most common choices. But it doesn't sound the type of project you could do without one.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
Digital Troubleshooting and testing	walters	General Electronics Chat	38	24th August 2005 09:21 AM
faulty digital components testing,checking	walters	General Electronics Chat	5	22nd August 2005 08:10 PM
digital logic probe	dewey	General Electronics Chat	2	22nd March 2005 06:27 PM
digital logic subtrator	atifshabir	General Electronics Chat	1	24th February 2005 10:50 AM
Digital logic questions...	sonaiko	General Electronics Chat	6	4th November 2004 06:42 PM

30th October 2008, 12:18 PM	(permalink)
jacks	Digital Logic testing Friends I want to test an 8 bit packet for errors i.e address and instruction/data of the packet. I am thinking serial to parallel shift register and the output exclusive ORed, back to the input of serial. How can I test the address and instruction data? If the packet is okay I want it to go turn a motor on a H-Bridge packet, is this possible? Probably use a DA converter. Thanks Jacks

30th October 2008, 12:33 PM	(permalink)
Nigel Goodwin	Do in a processor, a PIC would be suitable - and almost a single chip solution to the entire design. __________________ PIC programmer software, and PIC Tutorials at: http://www.winpicprog.co.uk

30th October 2008, 12:51 PM	(permalink)
jacks	Nigel Thanks for your response. How will I test it on a PIC? Is there a programming language I will have to learn? Thanks Jacks