Had anyone experienced any problems on using CD4051 analog multiplexer regarding crosstalk? Is there a relation between the supply voltage with the crosstalk?

I use 5 volt supply for it. And inputs on the CD4051 ranges from 0 to 5V linear.

Any suggestions??

Use a lower impedance (and therefore more distortion) on the inputs of the "receiving" circuits, or use more multiplexers to switch the unselected receiving circuits to a low impedance idle voltage.

can i use CD4051/52/53 for mobile phone switching?
In my project i have to receive the call from mobile to hand set out of 5 mobiles. when any other will ring i have to disconnect first one and receive the second..